We are running a survey to help us improve the experience for all of our members. If you see the survey appear, please take the time to tell us about your experience if you can.
When I try to run the debugger I get a ULINK - arm error:
"This product requires ULINK2"
I have v3.53 and ULINK V2.10...
This is my first time around the block. Is the message saying that my USB debugger/programmer is not a ULINK2 device? Help!
Hi Reinhard,
I might have purchased a debugger from your company but to tell you the truth, I didn't even know that your company had these or in fact that your company even existed, until I was interested in microcontrollers. And only by way of the vendor who sold me the board and the debugger (on eBay) was I pointed to Keil software. Now that your software can reject these 'incompatable' debuggers it looks like I need to buy one from you, but the initial experience I must report is poor, because I must first fill out a request form with nearly 100 item that I must scan over or fill in, just to get a price. At least my vendor who was MDFly offered me in comparison greater convenience. Please don't underestimate the value of convenience to your customers. Click and buy is also not supported by your company. Good luck.
Cluck and buy may be important if I buy films or music.
When I buy an expensive development tool, I normally don't take it on my credit card but want it invoiced.
But I have to admit that I think Keil has too many required info fields on their forms. I tend to give very stupid answers when I get annoyed by required fields that should have been optional. The advantage with that is that it destroys any statistics collection way more than if the fields had been optional and the user could have chosen to answer or not.