• State Not Answered
  • Locked Locked
  • Replies 5 replies
  • Subscribers 21 subscribers
  • Views 1418 views
  • Users 0 members are here
2025 survey

We are running a survey to help us improve the experience for all of our members. If you see the survey appear, please take the time to tell us about your experience if you can.

Options
Related
How was your experience today?
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

mcb2300 - power cycle and reset

Genp

I've noticed that mcb2300 doesn't start after power cycling (http_demo), but starts ok after reset.
Is there any way to fix it?

Parents
  • 0 in reply to Genp

    misterious...
    I've started my own project, using http_demo settings.
    As I mentioned earlier, LPC2300.s files from the Keil installation directory and from Http_demo are different, so not to spend time for baud rate calculations I used the same setting for PLL as in Http_demo.
    Now the board works after power cycle (and i swear it didn't work for Http_demo).
    Well, I need to figure out where the mistery is (don't like hard-/software misteries..)

Reply
  • 0 in reply to Genp

    misterious...
    I've started my own project, using http_demo settings.
    As I mentioned earlier, LPC2300.s files from the Keil installation directory and from Http_demo are different, so not to spend time for baud rate calculations I used the same setting for PLL as in Http_demo.
    Now the board works after power cycle (and i swear it didn't work for Http_demo).
    Well, I need to figure out where the mistery is (don't like hard-/software misteries..)

Children
No data