I've noticed that mcb2300 doesn't start after power cycling (http_demo), but starts ok after reset. Is there any way to fix it?
unplugging and replugging power connector.
misterious... I've started my own project, using http_demo settings. As I mentioned earlier, LPC2300.s files from the Keil installation directory and from Http_demo are different, so not to spend time for baud rate calculations I used the same setting for PLL as in Http_demo. Now the board works after power cycle (and i swear it didn't work for Http_demo). Well, I need to figure out where the mistery is (don't like hard-/software misteries..)