Please note: We are aware of an issue affecting replies on the Arm Community forums, which may not be loading as expected.
We apologize for any inconvenience and appreciate your patience while we investigate and work to resolve the issue.
Thank you for your understanding.
Hi am trying to find out the required AT command set for a microcontroller to connect through rs232 to a modem and call a number. i can do so with hyperterminal with ATDT then number. is this sufficient for the pic to send this.
With AT set do i need to ECHO (E1)? Set Baud rate? Set Asyncronous(&Mn)
Any HELP please
"Your modem doesn't know - or care - what hardware and software you use to communicate with it."
Absolutely!
See:
http://www.keil.com/forum/docs/thread9113.asp
http://www.keil.com/forum/docs/thread9265.asp