Hi all,
CAN Pins TD2,RD1,RD2 are given GPIO pions in lpc2129 etc.whereas TD1 is function specific pin. why is it so?? is there any specific reason for this?
i am using MCB2100 (LPC2129) with ULINK debugger. i by mistake connected TD1 pin to gnd and ULINK was not able to communicate???? when i removed it worked... whts d reason for this?
Thanks, Dimple
ok.. i wanted to now this because, when (by mistake) i pulled down this pin by 10K supply was getting loaded.
Thanks, Dimple.