This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

slog with ULINK and MCB2100 board

I have successfully used the uVision3 slog command to divert printf() data to a text file using an Infineon C164 processor connected via a serial link. However I'm unsure how this works with the ARM processor where downloads and control use the JTAG interface via a Keil ULINK module.

Any help would be appreciated.

Don

Parents

0 Don Weston over 19 years ago in reply to Keil Software Support Intl.

Hi Reinhard,

Thanks for your help, I will check the MCB2100 example programs. Perhaps I have missed something but the fact that slog is not supported here does not seem to be very well documented.

Regards,

Don
Cancel
Vote up 0 Vote down

Cancel

Reply

0 Don Weston over 19 years ago in reply to Keil Software Support Intl.

Hi Reinhard,

Thanks for your help, I will check the MCB2100 example programs. Perhaps I have missed something but the fact that slog is not supported here does not seem to be very well documented.

Regards,

Don
Cancel
Vote up 0 Vote down

Cancel

Children

No data