We are running a survey to help us improve the experience for all of our members. If you see the survey appear, please take the time to tell us about your experience if you can.
Hi I am currently using the MCB2140 Board as a USB-powered device (the default). However I want to power it using some alternate method. The only documentation I found was "Remove the 0 Ohm resistor (R37) to use the VIN connector P14 as an external power supply connection." on the user manual of mcb2140. It is not very clear how to go about doing this - could anyone pl explain.
Thanks
Regards Ramesh Kumar
This should help: http://www.keil.com/support/docs/3141.htm