This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

uvision not seeing changed flash

Hello,

I'm debugging a firmware update problem and notice that uVison2 and 3 do not refresh the dissasembly or code memory views.

In other words, my app writes the new code into flash, but Uvision still thinks the old code is there.

Is there a way to get the latest version of uVision to refresh it's view of flash?

Thanks,

Mark

Parents
  • OOPS
    was not clear WILL, do as to reading memory contents not as to 'connecting' source and memory contents after "a loade it did not know of", .
    I can not even visualize any debugger that would be able to 'connect' code that has been loaded by other means than the debuggers load command to the memory contents.

    Erik

Reply
  • OOPS
    was not clear WILL, do as to reading memory contents not as to 'connecting' source and memory contents after "a loade it did not know of", .
    I can not even visualize any debugger that would be able to 'connect' code that has been loaded by other means than the debuggers load command to the memory contents.

    Erik

Children
No data