This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

uvision not seeing changed flash

Hello,

I'm debugging a firmware update problem and notice that uVison2 and 3 do not refresh the dissasembly or code memory views.

In other words, my app writes the new code into flash, but Uvision still thinks the old code is there.

Is there a way to get the latest version of uVision to refresh it's view of flash?

Thanks,

Mark

Parents Reply Children
  • OOPS
    was not clear WILL, do as to reading memory contents not as to 'connecting' source and memory contents after "a loade it did not know of", .
    I can not even visualize any debugger that would be able to 'connect' code that has been loaded by other means than the debuggers load command to the memory contents.

    Erik