This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

uvision not seeing changed flash

Hello,

I'm debugging a firmware update problem and notice that uVison2 and 3 do not refresh the dissasembly or code memory views.

In other words, my app writes the new code into flash, but Uvision still thinks the old code is there.

Is there a way to get the latest version of uVision to refresh it's view of flash?

Thanks,

Mark

Parents
  • "It takes considerable time to make sure the everything is set up properly in the SiLab ide to match the settings of Uvision in order to create the exact image"

    As a workaround, can you not just load the image built by uVision into the SiLabs IDE for this?

    "I don't want to use some crappy IDE, when the best tool just needs to refresh it's (sic) view of flash."

    Have you contacted Keil support about this?

Reply
  • "It takes considerable time to make sure the everything is set up properly in the SiLab ide to match the settings of Uvision in order to create the exact image"

    As a workaround, can you not just load the image built by uVision into the SiLabs IDE for this?

    "I don't want to use some crappy IDE, when the best tool just needs to refresh it's (sic) view of flash."

    Have you contacted Keil support about this?

Children