This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

uvision not seeing changed flash

Hello,

I'm debugging a firmware update problem and notice that uVison2 and 3 do not refresh the dissasembly or code memory views.

In other words, my app writes the new code into flash, but Uvision still thinks the old code is there.

Is there a way to get the latest version of uVision to refresh it's view of flash?

Thanks,

Mark

Parents
  • Than what is the problem, you just staed that it woeks.

    Is it that you are incapable of working outside the Keil IDE?

    I have used the SiLab ide for issues like this. It takes considerable time to make sure the everything is set up properly in the SiLab ide to match the settings of Uvision in order to create the exact image. This can take hours.

    I don't want to use some crappy IDE, when the best tool just needs to refresh it's view of flash. This is not a difficult concept.

Reply
  • Than what is the problem, you just staed that it woeks.

    Is it that you are incapable of working outside the Keil IDE?

    I have used the SiLab ide for issues like this. It takes considerable time to make sure the everything is set up properly in the SiLab ide to match the settings of Uvision in order to create the exact image. This can take hours.

    I don't want to use some crappy IDE, when the best tool just needs to refresh it's view of flash. This is not a difficult concept.

Children
  • "It takes considerable time to make sure the everything is set up properly in the SiLab ide to match the settings of Uvision in order to create the exact image"

    As a workaround, can you not just load the image built by uVision into the SiLabs IDE for this?

    "I don't want to use some crappy IDE, when the best tool just needs to refresh it's (sic) view of flash."

    Have you contacted Keil support about this?

  • What did you want to say.?

    "I don't want to use some crappy IDE, when the best tool just needs to refresh it's (sic) view of flash."
    whats sic in that,

    Have you contacted Keil support about this?
    Keil being BUSY, has time for BASIC queries..?
    I wonder,