Hi In my project iam measuring the leak rate. The range of leak rate is 1.0E-11 to 1.0E-02.Up now I measured leak rate and displayed On the 7 segment display with 0.1 resolution. Here I used look up table method I taken hole Range values In the table and iam displaying the value for corresponding voltage . I stored values in the farm Of (1011 =1.0E-11) here "." ,"E","-" are constants. Now I want display the leak rate on BAR graph display. For 20 digits I have to take one led. The fallowing values I have to show on bar graph 1E-11, 3E-11, 5E-11, 7E-11, 9E-11, 1E-10, 3E-10, 5E-10…………………………………………2E-02 ex: 1E-11 = one led should glow 3E-11 = 2 leds should glow 5E-11 = 3 leds should glow : : : How to convert table values in to bar graph display. Thanks Regards
Avago Technologies; formerly Agilent; previously Hewlett-Packard (HP). As always, when using any electronic device, your first port of call should be the Support section of the manufacturer's website. There you should search for the Data sheet, Application Notes, and other supporting materials. Try this: http://www.avagotech.com/products/product-detail.jsp?navId=HDSP-4830