• State Not Answered
  • Locked Locked
  • Replies 3 replies
  • Subscribers 22 subscribers
  • Views 714 views
  • Users 0 members are here
Options
Related
How was your experience today?
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

ULINK2 problems on a MCB2300

Jay Shroff

Similar problem to one mentioned by Dejan.... but no solder short that I can see. Here's the problem

I've just got MCB2300 with LPC2378 on it and ULINK2 adapter. When I try to connect to the board, there's a messsage "JTAG communication failure" in the Target Driver Setup window. Also, serial no., ULINK version etc. are all grey. When I disconnect JTAG cable from the MCB2300 at least those come alive, showing ULINK's serial number, version etc.

Any ideas how to bring it to life? I've checked all jumpers and tried to power JTAG drivers from both 3.3V internal and from targer. All the same...

Thanks
Jay

Parents
  • 0 in reply to Suvidh Kankariya

    Hi Suvidh,

    Thanks for the tips, the upgrade did the trick, it's pretty sad that the CD that you get with the package never seems to work with the hardware. Wonder why Keil even bothers shipping a CD that will not work and just results in wasted effort.

    Oh well at least now the board's working great.

    Jay

Reply
  • 0 in reply to Suvidh Kankariya

    Hi Suvidh,

    Thanks for the tips, the upgrade did the trick, it's pretty sad that the CD that you get with the package never seems to work with the hardware. Wonder why Keil even bothers shipping a CD that will not work and just results in wasted effort.

    Oh well at least now the board's working great.

    Jay

Children