Hi all, I am having a problem with the simulation of my project which uses both external Interrupts, Interrupt 0 and Interrupt 2. I enable all the signals necessary to enable the Interrupts. When in simulation I lower the Bit 1.4, the Interrupt 2 routine is executed, but when i lower P1.3 in simulation, the interrupt 0 is not executed. Is there a problem with simulator or any other clue. Best wishes, (i havent tested yet on the evaluation board, but in simulation it doesnt work, maybe others have the same problem) thank you, any help is appreciated Khaled
Sorry, we cannot duplicate this problem here. Can you supply a test case that shows this problem. You may email it to: support.intl@keil.com Reinhard