Documentation (uVision or dScope): >The serial output may be also assigned to a PC >COM port using the ASSIGN command. Could anybody give a working example, how to do it for C167 microcontrollers ? I doubt that works...
commands: MODE COM1 57600 ASSIGN COM1 > NUL work, but these commands do not redirect PC's COM1 to the Serial Window. Otherwise it asks for registers ?! < (input regeister) > (output register) Why these registers, if it's just a RS232 serial COM port of a PC ? Which are proper paramaters? What are these magic registers ? My application program is running in a real C167 microcontroller, not under debugger simulation.
You need to read the uVision Debug Commands online help; it describes each of the uVision Debug Commands - including telling you what the parameters mean!
http://www.keil.com/support/man/docs/mon166/mon166_debug.htm > Do not initialize the serial interface in > your user application. > The monitor configures the UART. Unfortunately, I need to communicate to my program directly (without monitor). For my application, monitor is only needed for Bootstrap, loading and as a simple TERMINAL. Where is this "uVision Debug Commands online help" ? Can You give me a link to this ?
"Where is this 'uVision Debug Commands' online help?" OK, back to basics: You need to start by reading the uVision Getting Started Guide, and working through the example projects in it. This will give you a proper introduction to the tools, how they work, and how to use them - rather than just jumping-in blindly at the deep end. (The uVision Getting Started Guide is available on the 'Books' tab in the 'Project' Window; The 'Books' window is also available via the 'Help' menu; failing all that, search for GS*.PDF in your Keil folder)
Unfortunately, I need to communicate to my program directly (without monitor). For my application, monitor is only needed for Bootstrap, loading and as a simple TERMINAL. You have to use the "simulated serial mode" to connect uVision and your C167. It uses two unused I/O-pins. This will free the serial interface of the C167. See the "getting started...".
Thanks! It's working now. I had to disable "serial interrupt" in debugger target configuration. Best regards.