Documentation (uVision or dScope): >The serial output may be also assigned to a PC >COM port using the ASSIGN command. Could anybody give a working example, how to do it for C167 microcontrollers ? I doubt that works...
"Where is this 'uVision Debug Commands' online help?" OK, back to basics: You need to start by reading the uVision Getting Started Guide, and working through the example projects in it. This will give you a proper introduction to the tools, how they work, and how to use them - rather than just jumping-in blindly at the deep end. (The uVision Getting Started Guide is available on the 'Books' tab in the 'Project' Window; The 'Books' window is also available via the 'Help' menu; failing all that, search for GS*.PDF in your Keil folder)