Hi I am using XC164CS Infineon Boards Rev 200. I configured DIP settings for Boards as mentioned in Keil "Monitor for Infineon XC16Board REV 200". I am unable to use CCU6 Pin because these pin's are used as address bus in Monitor Program. Please let me know any other configuration to check CCU6 module i/o pins. Thank's in advance. regards Sheshadri
For a check only of the CCU6 module you can use the OCDS with on-board wiggler. But OCDS pins are shared with port 3. That means the functions (like ASC0) cannot be used at the time you testing your CCU6 module. Else as Reinhard says use XC167 for the test. But this make sense also only with OCDS. Another configuration is not possible, if you use the monitor with bus accesses. If the pins works as address bus there is no chance to access the CCU6 and vice versa. Stefan