• State Not Answered
  • Locked Locked
  • Replies 3 replies
  • Subscribers 21 subscribers
  • Views 929 views
  • Users 0 members are here
2025 survey

We are running a survey to help us improve the experience for all of our members. If you see the survey appear, please take the time to tell us about your experience if you can.

Options
Related
How was your experience today?
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

serial windows #1 will not switch to hex-mode

Martin Weide

my project puts data to the serial port.
Only ASCII data is displayed and the hex-mode is not usable.

The configuarion is:
- Interrupt mode (RX and TX) for the serial channel
- Timer-2 for baudrate

What can I do?

Parents
  • 0 in reply to Martin Weide

    "It is not possible to switch to HEX-Mode in the serial-window! uVision is switching back to ASCII-Mode."

    So it does! :-(

    I just tried it:
    1. right-click in the serial window - 'ASCII' is checked in the pop-up menu;
    2. click on 'Hex' - the check mark doesn't seem to move, and the pop-up closes immediately.
    3. right-click again in the serial window - to check the setting - 'ASCII' is still checked in the pop-up menu! :-(

    Looks like a bug, then?

Reply
  • 0 in reply to Martin Weide

    "It is not possible to switch to HEX-Mode in the serial-window! uVision is switching back to ASCII-Mode."

    So it does! :-(

    I just tried it:
    1. right-click in the serial window - 'ASCII' is checked in the pop-up menu;
    2. click on 'Hex' - the check mark doesn't seem to move, and the pop-up closes immediately.
    3. right-click again in the serial window - to check the setting - 'ASCII' is still checked in the pop-up menu! :-(

    Looks like a bug, then?

Children
No data