Use the "CommandLine" to promile my files,how can i config the device?

All the command-line options are described in the Manauls.

Or, select the required options in the uVision GUI dialogues, then look at the resulting command-lines that uVision uses - these are shown in the options dialogues.

Or, run the whole uVision Build process from the command-line - see the Manual

All the command-line options are described in the Manauls.

Or, select the required options in the uVision GUI dialogues, then look at the resulting command-lines that uVision uses - these are shown in the options dialogues.

Or, run the whole uVision Build process from the command-line - see the Manual