This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Memory Maps LOAD SAVE

I am using a Dallas 390 in continous mode and I am trying to store configuration memory using the simulator LOAD and SAVE commands.

To save the memory map I am using the following command

SAVE bbram.HEX X:0x100000, X:0x107FF8

This appears to save the data from the memory map into an intel hex file as I expected. But when I use the following load command to reload the memory map it appears to do nothing.

LOAD bbram.HEX

Anyone know what I am doing wrong ?

Parents

0 Stuart Wright over 22 years ago in reply to Keil Support Intl.

The simulation DLL: S8051.dll reports as version 2.34
Cancel
Vote up 0 Vote down

Cancel

Reply

0 Stuart Wright over 22 years ago in reply to Keil Support Intl.

The simulation DLL: S8051.dll reports as version 2.34
Cancel
Vote up 0 Vote down

Cancel

Children

0 Keil Support Intl. over 22 years ago in reply to Stuart Wright

Can you send an example to email:
support.intl@keil.com so that we can duplicate your problem.
Cancel
Vote up 0 Vote down

Cancel