• State Not Answered
  • Locked Locked
  • Replies 4 replies
  • Subscribers 22 subscribers
  • Views 1074 views
  • Users 0 members are here
Options
Related
How was your experience today?
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

XC16CJ three questions

Joao Martins

Hi,

I have three questions regarding Infineon microcontroller C161CJ:

1) Is it fully supported by KEIL?

2) It has OCDS : On chip Debug Support.
Can KEIL software use this? If so Is there any information regarding the cable connections to the PC?

3) It has a flash memory.
Does anyone on this Forum has ever used? I am with the usual problems of very little time to do the hardware and the software and I would like to know if someone has already made some code to write parameters on the internal flash. I do not know if it is troublesome or not! If so I might think on using one external SEEPROM:)


Thanks All & Best regards,
Joao










Parents
  • 0 in reply to Jon Ward

    Thanks Jon,

    I Have sent the requset for this to our logistic department.
    I am completing the schematic and really need to know what connections shall I put in my board to connect to the ulink cable.
    Can you give me details about the circuit for the OCDS.

    Is it? - from Infineon ap24001.pdf:
    "
    The connector is a standard 2.54 mm (0.1 inch) centres.
    TMS 1 - 2 VDD
    TDO 3 - 4 GND
    CPU_CLOCK 5 - 6 GND
    TDI 7 - 8 RESET
    TRST 9 - 10 BRKOUT
    TCK 11 - 12 GND
    BRKIN 13 - 14 OCDSE
    RCAP1 15 - 16 RCAP2

    WITH :
    The following signals should be connected to pull-ups pull-downs of 10 kΩ respectively
    on the cpu board.
    – OCDS, TMS, TCK, TDI, TRST, RESET, BRKIN

    "


    Also I am not placing external RAMs on board.
    Is it ok for ulink? That is it can run only with the microcontroller?


    Any other circuit requirements?


    Thanks,
    Joao



Reply
  • 0 in reply to Jon Ward

    Thanks Jon,

    I Have sent the requset for this to our logistic department.
    I am completing the schematic and really need to know what connections shall I put in my board to connect to the ulink cable.
    Can you give me details about the circuit for the OCDS.

    Is it? - from Infineon ap24001.pdf:
    "
    The connector is a standard 2.54 mm (0.1 inch) centres.
    TMS 1 - 2 VDD
    TDO 3 - 4 GND
    CPU_CLOCK 5 - 6 GND
    TDI 7 - 8 RESET
    TRST 9 - 10 BRKOUT
    TCK 11 - 12 GND
    BRKIN 13 - 14 OCDSE
    RCAP1 15 - 16 RCAP2

    WITH :
    The following signals should be connected to pull-ups pull-downs of 10 kΩ respectively
    on the cpu board.
    – OCDS, TMS, TCK, TDI, TRST, RESET, BRKIN

    "


    Also I am not placing external RAMs on board.
    Is it ok for ulink? That is it can run only with the microcontroller?


    Any other circuit requirements?


    Thanks,
    Joao



Children