We are running a survey to help us improve the experience for all of our members. If you see the survey appear, please take the time to tell us about your experience if you can.
Greetings,
sir/madam i am working on serial wire debug protocol. I was implemented serial wire debug protocol, which was successfully tested for used controllers like xmc1100,xmc4500..etc, when i tried to Access the control on newer controller i.e xmc1100 it is not taking the SWD commands by searching on internet i notified by one point that if the controller is with ASC_BSL as boot mode index we can't access, we must change the BMI value to SWD0 in order to access with serial wire debug protocol, i am not getting how to change the Boot mode index could you please tell me how can i change BMI to SWD0 manually by using SWD protocol??