• State Accepted Answer
  • Locked Locked
  • Replies 3 replies
  • Answers 1 answer
  • Subscribers 22 subscribers
  • Views 1808 views
  • Users 0 members are here
Options
Related
How was your experience today?
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Can't connect to Armv-A Base RevC AEM FVP via SSH

josecm

I'm trying to connect via ssh to a Buildroot Linux instance running in an Armv-A Base RevC AEM FVP. These are the parameters I'm using:

FVP_Base_RevC-2xAEMvA \
    -C bp.smsc_91c111.enabled=true -C bp.hostbridge.userNetworking=true \
    -C bp.hostbridge.userNetPorts=127.0.0.1:8022=22 -C bp.hostbridge.userNetSubnet=10.0.2.0/23 \
    ....
 
Then I try to connect by running `ssh root@localhost -p 8022`, but the command just hangs.
I'm pretty sure Linux is working correctly as running the same exact Linux image in the Armv-A Foundation AEM FVP model works as expected. These are the parameters used:
Foundation_Platform \
    --network=nat \
    --network-nat-subnet=10.0.2.0/23 \
    --network-nat-ports=127.0.0.1:8022=22 \
    ....
Any idea on where I'm doing something wrong? And how to fix it?
Parents
  • 0

    Can you please check  the two things below?

    • Which version of FVP are you using?
    • Which version of AEMFVP-A sw stack (located in the gitlab repository) are you using?

    As noted in the user guide of the AEMFVP-A sw stack above, each release of sw stack has a recommended version of FVP.. Unless any specific reason, the recommended version of FVP should be used.

Reply
  • 0

    Can you please check  the two things below?

    • Which version of FVP are you using?
    • Which version of AEMFVP-A sw stack (located in the gitlab repository) are you using?

    As noted in the user guide of the AEMFVP-A sw stack above, each release of sw stack has a recommended version of FVP.. Unless any specific reason, the recommended version of FVP should be used.

Children