Arm Development Platforms forum DSTREAM update fireware failed

State Accepted Answer
+1 person also asked this people also asked this
Locked Locked
Replies 3 replies
Subscribers 21 subscribers
Views 1700 views
Users 0 members are here

Options

Related

How was your experience today?

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

DSTREAM update fireware failed

danny2022 over 2 years ago

i use arm develop studio 2021.01 version "Debug hardware fireware installer " update Dstream fireware failed.

Progress bar stuck at 90%, prompt timeout

Top replies

Parents

+1 Ronan Synnott over 2 years ago

Hello, it seems the unit firmware updated correctly. If you power cycle, does it reboot successfully? If you connect again with the same firmware installer utility it should report that the unit now has v7.4.0 installed.

If not, you may need to perform a complete restore:
https://developer.arm.com/documentation/100955/0529/Introduction-to-Arm-DSTREAM/Restoring-a-DSTREAM-unit-that-fails-to-boot
Cancel
Up +2 Down

Cancel

Reply

+1 Ronan Synnott over 2 years ago

Hello, it seems the unit firmware updated correctly. If you power cycle, does it reboot successfully? If you connect again with the same firmware installer utility it should report that the unit now has v7.4.0 installed.

If not, you may need to perform a complete restore:
https://developer.arm.com/documentation/100955/0529/Introduction-to-Arm-DSTREAM/Restoring-a-DSTREAM-unit-that-fails-to-boot
Cancel
Up +2 Down

Cancel

Children

+1 danny2022 over 2 years ago in reply to Ronan Synnott

Thank you, i have fix it
Cancel
Up +2 Down

Cancel