We are running a survey to help us improve the experience for all of our members. If you see the survey appear, please take the time to tell us about your experience if you can.
I am trying use pre build image from /Processors/Cortex Family/Cortex-M/Cortex-M3 DesignStart Eval (arm.com)
trying make AN511 work, but I am getting following error , any one managed to port Cortex M3 design start ???
ARM V2M-MPS2 CMSIS-DAP Firmware v2.1.7Build Date: Aug 19 2015
MotherBoard Revision C Variant AMotherBoard Serial Number 0283100101-0095
ARM V2M Boot Loader v1.0.0
Switching on main power...
Configuring motherboard (rev C, var A)...
Reading Board File \MB\HBI0263C\AN511\an511_v1.txt
Configuring FPGA from file \MB\HBI0263C\AN511\an511_v1.rbe
ERROR: FPGA did not configure.
Failed to program FPGA...
Even with ARM V2M-MPS2 CMSIS-DAP Firmware v2.2.1 same error,
ARM V2M-MPS2 CMSIS-DAP Firmware v2.2.1Build Date: Mar 8 2017
Time : 00:10:24 Date : 01:01:2000
Powering down...
Hi again, searching for this particular error, it may well be that your board is damaged :(https://community.arm.com/developer/tools-software/oss-platforms/f/dev-platforms-forum/9686/v2m-mps2-error-fpga-did-not-configure
I recommend raising an official support case from the support menu above.
but other applications are loading fine AN385 etc
only AN511 is not getting loaded
I'm sorry, I can't explain that - it works without issue for me.
I suggest you raise an official support case.