I am trying use pre build image from /Processors/Cortex Family/Cortex-M/Cortex-M3 DesignStart Eval (arm.com)
trying make AN511 work, but I am getting following error , any one managed to port Cortex M3 design start ???
ARM V2M-MPS2 CMSIS-DAP Firmware v2.1.7Build Date: Aug 19 2015
MotherBoard Revision C Variant AMotherBoard Serial Number 0283100101-0095
ARM V2M Boot Loader v1.0.0
Switching on main power...
Configuring motherboard (rev C, var A)...
Reading Board File \MB\HBI0263C\AN511\an511_v1.txt
Configuring FPGA from file \MB\HBI0263C\AN511\an511_v1.rbe
ERROR: FPGA did not configure.
Failed to program FPGA...
but other applications are loading fine AN385 etc
only AN511 is not getting loaded
I'm sorry, I can't explain that - it works without issue for me.
I suggest you raise an official support case.