Support forums

Arm Development Platforms forum Coresight not getting enabled in juno

State Suggested Answer
Locked Locked
Replies 2 replies
Answers 1 answer
Subscribers 22 subscribers
Views 16020 views
Users 0 members are here

Options

How was your experience today?

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Coresight not getting enabled in juno

HKHK over 6 years ago

I am booting the juno board with coresight enabled in config file and the nodes in DT file are also correctly kept then also the coresight components are not getting registered though the board is booting

Top replies

Ash Wilding over 6 years ago +1 suggested

Hi, Please can you make sure you follow these instructions to download and install the latest board firmware on your Juno; it's possible you're using an old system control processor (SCP) firmware blob...

Parents

0 Sudeep Holla over 5 years ago

Can you provide details on which kernel and dtbs are you using ?

I checked the latest 18.10 release but the DTBs are empty there, so I need to check the DTB you are running ?
Cancel
Up 0 Down

Cancel

Reply

0 Sudeep Holla over 5 years ago

Can you provide details on which kernel and dtbs are you using ?

I checked the latest 18.10 release but the DTBs are empty there, so I need to check the DTB you are running ?
Cancel
Up 0 Down

Cancel

Children

No data