This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

ARM 7 TDMI

Hello I am new to this forum and new to Arm 7 programming.

My question is - I have a programming (I think it is a Flash) file in hex ,which I downloaded to Arm 7 MCU through Rlink usb tool to run the programme.

If I need to modify this programme how do I do this?

Thanks

Top replies

Chris Shore over 10 years ago +1 verified

There are two possible answers to your question...but it sounds like you have a lot of background on embedded development to make up! - If you have the source code, you can recompile the program and generate...

Parents

0 Jagath over 9 years ago in reply to Yasuhiko Koumoto

Thanks for your instructions. I'll try this and let you know the result.
Cancel
Up 0 Down

Cancel

Reply

0 Jagath over 9 years ago in reply to Yasuhiko Koumoto

Thanks for your instructions. I'll try this and let you know the result.
Cancel
Up 0 Down

Cancel

Children

0 Yasuhiko Koumoto over 9 years ago in reply to Jagath

i, I reccommend GCC ARM Embedded in Launchpad as the dis-assembler (i.e. objdump) because some the other dis-assembler could not dis-assemble successfully the elf code generated by my procedure. It seems to be good.
Best regards,
Yasuhiko Koumoto.
Cancel
Up 0 Down

Cancel
0 Jerome Decamps - 杜尚杰 over 9 years ago in reply to Yasuhiko Koumoto

I approve this solution
Cancel
Up 0 Down

Cancel