• Locked Locked
  • Replies 9 replies
  • Subscribers 118 subscribers
  • Views 7419 views
  • Users 0 members are here
Options
Related
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Prefetch Abort due to unaligned PC.

Nikhil Girdhar
Note: This was originally posted on 22nd August 2011 at http://forums.arm.com

Hi,

I am working on ARM1136 processor in Thumb mode.

Problem

I am getting a prefetch abort while executing an instruction. Program Counter at this instant is odd.



Description

My source code has few instructions as below...

                            ....
                        [color=#FF0000]    [/color]bx lr   [color=#FF0000]       [/color];lr = 0xB76B2A39 i.e. some odd value


After executing this instruction the code jumps to the  location 0xB76B2A38 (pc = lr & 0xFFFFFFFE) which has the instruction as below

Address 0xB76B2A38:   [color=#FF0000]  [/color]ldr r0, #0xB76B5DAC [color=#FF0000]    [/color];prefetch abort.

The above instruction generates a prefetch abort as the pc value is odd 0xB76B2A39.



BX Instruction description

BX Rm instruction ensures that the location that you jump to is half a word aligned. i.e. pc = lr & 0xFFFFFFE

ARM thumb mode requires that pc should always be half a word aligned.



In this case pc alignment (to be done by the processor) did not take place. How can I figure out whether the processor is goofing up or there is some software issue?

Thank you.
Nikhil.
Parents Reply Children
No data