This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

How can I manually add target in RVDS 4.1?

Note: This was originally posted on 26th December 2010 at http://forums.arm.com

I installed Carbon SoC Designer and then RVDS 4.1. The RVDS was supposed to include SOC Designer in its target list,( it was supposed to be like the image below ) but SoC Designer did not show up.
I tried reinstalling for several times and the sad result remains.
So I was wondering if there are ways to manually add target in RVDS 4.1
Thank u~

Xin Jin over 12 years ago

Note: This was originally posted on 1st January 2011 at http://forums.arm.com

Try the following...

* Launch SoC Designer and load the simulation
* Launch RVD and open the "Connect to Target" dialog
* Click on Add next to the "SoC Designer" entry

The picture I posted was a normal situation, but mine does not have SoC Designer inside the list, that's the point.
Cancel
Vote up 0 Vote down

Cancel
Xin Jin over 12 years ago

Note: This was originally posted on 4th January 2011 at http://forums.arm.com

What do you have in your list?

Thanks for replying.
I have reinstalled WinXP to solve the problem once for all ^^ i don't remember what was in the list.
Cancel
Vote up 0 Vote down

Cancel
Martin Weidmann over 12 years ago

Note: This was originally posted on 31st December 2010 at http://forums.arm.com

Try the following...

* Launch SoC Designer and load the simulation
* Launch RVD and open the "Connect to Target" dialog
* Click on Add next to the "SoC Designer" entry
Cancel
Vote up 0 Vote down

Cancel
Martin Weidmann over 12 years ago

Note: This was originally posted on 4th January 2011 at http://forums.arm.com

What do you have in your list?
Cancel
Vote up 0 Vote down

Cancel