This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Cortex-M3 access via SW

Note: This was originally posted on 31st March 2010 at http://forums.arm.com

Hi everybody

I have a reference platform containing an ARM Cortex-M3 with the SW interface (2 wire standard). I have RVDS v3.0 and a Multi-ICE. Can I configure the multi-ICE to access the Cortex via SW interface? How?

Bests

Parents

Reza Purtoosi over 12 years ago

Note: This was originally posted on 1st April 2010 at http://forums.arm.com

Multi-ICE does not support the Serial-Wire debug protocol. It only support JTAG operations.

Thanks for the information. Is there any other ARM JTAG box supporting the SW interface that I can use with RVDS v3.0?

Bests
Cancel
Vote up 0 Vote down

Cancel

Reply

Reza Purtoosi over 12 years ago

Note: This was originally posted on 1st April 2010 at http://forums.arm.com

Multi-ICE does not support the Serial-Wire debug protocol. It only support JTAG operations.

Thanks for the information. Is there any other ARM JTAG box supporting the SW interface that I can use with RVDS v3.0?

Bests
Cancel
Vote up 0 Vote down

Cancel

Children

No data