This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Performance issue between 2 beagel boards.

Note: This was originally posted on 29th December 2009 at http://forums.arm.com

hi,
              Thanks in advance for any help to the question below.....

     I am facing a performance issue, while profiling on 2 beagle boards(Revision-2 board and Revision-3 board)
     The performance is dropping when profiling is done on the revision-3 beagle board by 5%.
     I am not able to figure out the exact reason behind this.
     The board details are:
     board 1: Processor       : ARMv7 Processor rev 2 (v7l)
      BogoMIPS        : 473.71
     board 2: Processor       : ARMv7 Processor rev 3 (v7l)
      BogoMIPS        : 491.57

     Please suggest me a way out of this...?

Parents

Peter Harris over 12 years ago

Note: This was originally posted on 5th January 2010 at http://forums.arm.com

I believe that the later board revision includes a newer version of the OMAP3 chip, which would explain the changed performance figure.
Cancel
Vote up 0 Vote down

Cancel

Reply

Peter Harris over 12 years ago

Note: This was originally posted on 5th January 2010 at http://forums.arm.com

I believe that the later board revision includes a newer version of the OMAP3 chip, which would explain the changed performance figure.
Cancel
Vote up 0 Vote down

Cancel

Children

No data