Please note: We are aware of an issue affecting replies on the Arm Community forums, which may not be loading as expected.

We apologize for any inconvenience and appreciate your patience while we investigate and work to resolve the issue.

Thank you for your understanding.

  • State Suggested Answer
  • Locked Locked
  • Replies 5 replies
  • Answers 1 answer
  • Subscribers 119 subscribers
  • Views 3759 views
  • Users 0 members are here
Options
Related
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

debug bare metal software on the Raspberry Pi 4 using Arm develop stdui by dstream

danny2022

i use ARM develop studio 2021.2,  debug by dstream. 

when i connect the rasperry PI4 .  it report this error message:

Unable to stop device Cortex-A72_0
Cannot attain state requested.
Unable to stop device Cortex-A72_0

config.txt

[pi4]
kernel=loop.bin

[all]
arm_64bit=1 #enable 64bit image
enable_uart=1 #enable pl uart
uart_2ndstage=1 #enable FW debug info

enable_jtag_gpio=1
gpio=22-27=a4
init_uart_clock=48000000
init_uart_baud=115200
#kernel_old=1 # if we set it, the image will be load at 0x0, otherwise the 64bit image will be load on 0x80000
#disable_commandline_tags=1 #Fix me, when set it, the image will be load on 0x0 ?

Parents Reply Children
  • 0 Arm Employee Badge in reply to danny2022

    Hi Danny

    My name is Stephen and I work at Arm.

    There is an example for Raspberry Pi 3 provided in the Arm DS examples (named "Raspberry-Pi-3_RAM" in Bare-metal_examples_Armv8.zip) that I would expect to work similarly for Raspberry Pi 4.

    In the Debug Configurations view, have you selected the configdb for Raspberry Pi 4 that is provided with Arm DS, or have you created your own?

    Please can you check that the jumper wires to connect the JTAG signals between DSTREAM/ULINK and Raspberry Pi are as described in the readme for Raspberry-Pi-3_RAM, and that config.txt contains just these lines:
    arm_64bit=1
    kernel_old=1
    enable_jtag_gpio=1
    disable_commandline_tags=1
                
    I will try to verify bare-metal debug on Raspberry Pi 4 myself in the next day or two.

    Stephen
         

  • 0 in reply to Stephen Theobald

    hi Stephen:


    thanks you very much

    1. I have selected the configdb for Rasperrby Pi4

    2. my config.txt contains  arm_64bit=1 and enable_jtag_gpio=1, because my code is running at 0x8000, so i do not cantains kernel_old=1 and disable_commandline_tags=1

    3. I put my program in that raspberry pi and it works

    4、I use openocd and jlink on ubuntu is debuggable

  • 0 in reply to Stephen Theobald

    hi Stephen:


    thanks you very much

    I found the reason, I didn't connect the ground of the raspberry pi4 and dstream,
    I thought the common ground was fine, only connect the ground of the raspberry pi4 and the computer.