This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

A basic debug control question

DavidAl over 4 years ago

When debugging in Arm Dev Studio I Connect to Target and then run my software. When I want to restart the program I disconnect and reconnect to the target. Is there an easier way to restart?

Top replies

Stephen Theobald over 4 years ago +1 verified

Hi David, Disconnecting (shutting down the FVP model) then reconnecting (restarting the FVP model) is usually the best way to restart a program because it guarantees that no processor state or previous...

Parents

0 DavidAl over 4 years ago in reply to Stephen Theobald

Hi Stephen,

Thank you, that is very helpful. Is it possible to configure the IDE to perform a Build whenever the Target is connected?

Best regards

David
Cancel
Vote up 0 Vote down

Cancel

Reply

0 DavidAl over 4 years ago in reply to Stephen Theobald

Hi Stephen,

Thank you, that is very helpful. Is it possible to configure the IDE to perform a Build whenever the Target is connected?

Best regards

David
Cancel
Vote up 0 Vote down

Cancel

Children

No data