Arm Development Studio forum Can a Physical Target be RESET using the Debugger Commands?

State Suggested Answer
Locked Locked
Replies 1 reply
Answers 1 answer
Subscribers 121 subscribers
Views 20117 views
Users 0 members are here

Options

Related

How was your experience today?

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Can a Physical Target be RESET using the Debugger Commands?

sska.73 over 4 years ago

I'm using DSTREAM with ARM DS-5 to program and Debug my FPGA with Cortex-R52. How Can I Reset my Target from the ARM DS-5 itself?

I've found a command "RESET" but where should I give the command? I'm new into this..

Top replies

Ronan Synnott over 4 years ago +1 suggested

Hello, you can use the "reset" command in the command pane in the debugger, else you can use this button (pulldown) in the debug control pane: Note you must also ensure that the DSTREAM is correctly connected...

0 Ronan Synnott over 4 years ago

Hello, you can use the "reset" command in the command pane in the debugger, else you can use this button (pulldown) in the debug control pane:

Note you must also ensure that the DSTREAM is correctly connected to the reset signals of the target, see:
https://developer.arm.com/docs/dui0499/latest/arm-dstream-system-design-guidelines/reset-signals/dstream-reset-signals
Cancel
Up +1 Down

Cancel