This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Connect Microchip SAMA5D27-SOM1-EK1 ...

Hi,

I installed ARM Development Studio with a 30-day evaluation to build the first prototype with Microchip SAMA5D27-SOM1-EK1. To my surprise I realized that I cannot connect to the card using JLink on board.

I then used the SEGGER J-link GDB, with which I connected without problems.

However, I can't find the method to connect ARM Development Studio to the local GDB to debug device.

Before changing the Jtag of the board to connect my ULINK2 I wanted to know if there is a possible solution ?

With ARM Development Studio, can't you remotely debug a custom board that uses a Bare Metal software ?

Thanks very much.

Top replies

Parents

0 debugasm over 5 years ago in reply to Stephen Theobald

Hi Stephen,

thank you very much for the detailed reply.

I will try to use ULINK2 after building a 20-pin 10-pin 1.27mm pitch adapter.

However, you confirm that remote debugging of a Bare Metal software is not possible at present. Will it be in the future ?
Cancel
Vote up 0 Vote down

Cancel

Reply

0 debugasm over 5 years ago in reply to Stephen Theobald

Hi Stephen,

thank you very much for the detailed reply.

I will try to use ULINK2 after building a 20-pin 10-pin 1.27mm pitch adapter.

However, you confirm that remote debugging of a Bare Metal software is not possible at present. Will it be in the future ?
Cancel
Vote up 0 Vote down

Cancel

Children

+1 Stephen Theobald over 5 years ago in reply to debugasm

Hi again debugasm

Bare-metal debug is performed via our range of JTAG/SWD debug units such as DSTREAM & uLINK, or via a CMSIS-DAP connection (over USB). Sorry, we have no plans to support bare-metal debug via a local GDB agent.

Stephen
Cancel
Vote up +1 Vote down

Cancel