This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Could not initialize class com.arm.productconfig.flex.X86FlexWrapper on DSTREAM connect

I am seeing a failure to connect to the DSTREAM debugger from DS-5 version 5.20

Just upgraded the debugger firmware to 4.20 which came with this DS-5 version.  When I double-click to connect I get this error.  Can't find any history on this problem.  Anyone seen this before?

Parents
  • Sorry you have experienced this - I had no issues after updating to DS-5 5.20.

    Based on the error message, I would assume this is a license based error.

    Open Help -> ARM License Manager. Does it report a valid license?

    Do you also get other errors, for example compiler errors?

    A boring answer may be to just reboot to make sure everything is properly installed.

    If the issue persists, please raise an official support request.

Reply
  • Sorry you have experienced this - I had no issues after updating to DS-5 5.20.

    Based on the error message, I would assume this is a license based error.

    Open Help -> ARM License Manager. Does it report a valid license?

    Do you also get other errors, for example compiler errors?

    A boring answer may be to just reboot to make sure everything is properly installed.

    If the issue persists, please raise an official support request.

Children