This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

DS5

Note: This was originally posted on 31st January 2011 at http://forums.arm.com

Hi,
I am facing an issue while i try to run a sample code in DS5.
The below mentioned error is being displayed.
"Cannnot run program "gdb": Launching Failed"
Can anyone provide me a solution to fix it?

Scott Douglass over 12 years ago

Note: This was originally posted on 31st January 2011 at http://forums.arm.com

It sounds like you might accidentally be using a host Debug configuration instead of one "DS-5 Debugger". Are you using one of the DS-5 examples? Can you be more specific about the steps you're taking to start the debug session including what the settings are in the debug configuration? It would also be useful to know what version of DS-5 you're using.
Cancel
Vote up 0 Vote down

Cancel
Balaji Sridharan over 12 years ago

Note: This was originally posted on 1st February 2011 at http://forums.arm.com

It sounds like you might accidentally be using a host Debug configuration instead of one "DS-5 Debugger". Are you using one of the DS-5 examples? Can you be more specific about the steps you're taking to start the debug session including what the settings are in the debug configuration? It would also be useful to know what version of DS-5 you're using.

Hi Scott,
Thanks for your response.
I am not using any example codes. It is just basic arithmetic operation i am doing.
After Build, i try to step through using the key F11.
While doing so i am getting the above mentioned error.

DS5 Details:
DS500-BN-00003-r5p0-02rel0.zip this i downloaded from net and installed in my pc.
Hope its version is 4.3
Cancel
Vote up 0 Vote down

Cancel
Scott Douglass over 12 years ago
Cancel
Vote up 0 Vote down

Cancel
Balaji Sridharan over 12 years ago
Cancel
Vote up 0 Vote down

Cancel
Scott Douglass over 12 years ago
Cancel
Vote up 0 Vote down

Cancel
Balaji Sridharan over 12 years ago
Cancel
Vote up 0 Vote down

Cancel
Scott Douglass over 12 years ago

Note: This was originally posted on 11th February 2011 at http://forums.arm.com

Is there any other version of DS5 which can be used as a simulator to run basic codes?

It's not hard to add a bit of C (or C++ or asm) code to the hello example and run/debug that.

But to answer your question: no: DS-5 doesn't support debugging a model at the bare-metal level, yet. It is scheduled to be added later this year. Even when it does the models typically need some initialization code (like real processors do) -- but there should be some example initialization code included.

By the way, DS-5 v5.4 is out now http://www.arm.com/ds5 (still no bare-metal model support though).
Cancel
Vote up 0 Vote down

Cancel
Balaji Sridharan over 12 years ago

Note: This was originally posted on 11th February 2011 at http://forums.arm.com

Hi Scott,

Thanks for your reply.....
Cancel
Vote up 0 Vote down

Cancel