We are running a survey to help us improve the experience for all of our members. If you see the survey appear, please take the time to tell us about your experience if you can.
Hi,
I have a couple of questions regarding generating traces on using the Tarmac trace plug-in. I'm using the FVP_VE_CortexA9x4 fixed virtual platform running Linaro Android.
1- I want to start trace generation at a specific point in time. When I use the start-instruction-count parameter to set the instruction count, I can only see the trace from CPU0 being generated. I don't see the traces from other CPUs. But if I don't use this parameter, I can (correctly) see the traces from all CPUs. Is this a bug?
2- When connecting the ModelDebugger to the running simulation, I cannot see the controls for the Tarmac trace plug-in in the "Set Parameters" section of the Debug menu for the CPU components. Is this also a bug?
3- Is there any way to selectively turn the tracing on/off in the middle of the simulation? I don't know a priori the instruction count that I need to start the tracing, and this makes the start-instruction-count parameter difficult to use.
Thanks,
Amin
Hi Amin,
Actually you can raise a support case. Please send an email to support-esl@arm.com using your official email. Someone will pick it up.
George