This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Running Model Debugger for more than one core

Note: This was originally posted on 15th July 2013 at http://forums.arm.com

Hello,

I try to run Model Debugger for ARMv8 target. It works fine if I choose to work with a single core.
If change ARM.NUM_CORES to be, for example, 2, then a window for the cpu0 opens normally,
but a window for cpu1 enters endless refresh loop (see the attached screenshot).

The only way to get out of it is to "kill -9" the model debugger process.

Can anyone please help to figure out what is going wrong?

Thank you,
Vitali

Parents

Vitali Sokhin over 12 years ago

Note: This was originally posted on 16th July 2013 at http://forums.arm.com

ModelDebugger is 8.0.030 connected to the ARMAEMv8AMPCT target and running on Linux 2.6.18-274.7.1.el5.

I solved the issue by rebooting my linux box. I think the behavior I observed is due to some weird interaction with X.

Vitali

Vitali,

Can you tell me which version of ModelDebugger you are using and the file name of the ARMv8 target you are using?

Chris
Cancel
Vote up 0 Vote down

Cancel

Reply

Vitali Sokhin over 12 years ago

Note: This was originally posted on 16th July 2013 at http://forums.arm.com

ModelDebugger is 8.0.030 connected to the ARMAEMv8AMPCT target and running on Linux 2.6.18-274.7.1.el5.

I solved the issue by rebooting my linux box. I think the behavior I observed is due to some weird interaction with X.

Vitali

Vitali,

Can you tell me which version of ModelDebugger you are using and the file name of the ARMv8 target you are using?

Chris
Cancel
Vote up 0 Vote down

Cancel

Children

No data