This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

CoreSight base addr and DAP port number

Note: This was originally posted on 28th March 2013 at http://forums.arm.com

hi, experts:
I am using a JTAG debugger.
It needs to set every cpu core's coresight base in the config page.
So, i have 2 questions:
1. no registers to record every cpu core's coresight base addr?
2. I also need to set DAP port number : 0/1
So, why need to set DAP port number?
I think it should be only 1 DAP port in ARM SOC.

best wishes,

Parents

china liu over 12 years ago

Note: This was originally posted on 2nd April 2013 at http://forums.arm.com

hi，Sandeep:
Thanks for your reply!
It seems every CPU core's CoreSight base addr is equal to the CoreSight's ROM table address?

best wishes,
Cancel
Vote up 0 Vote down

Cancel

Reply

china liu over 12 years ago

Note: This was originally posted on 2nd April 2013 at http://forums.arm.com

hi，Sandeep:
Thanks for your reply!
It seems every CPU core's CoreSight base addr is equal to the CoreSight's ROM table address?

best wishes,
Cancel
Vote up 0 Vote down

Cancel

Children

No data