This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

DS-5 fails to view Device Memory View

I am using DS-5 v5.27.1 and using ARM SGI-575 as development platform. platform have a range for RAM, serial and ethernet devices. At kernel/code level I have mapped all memories and able to read/write in these memory ranges but in command window/memory browser of DS-5 I am able to view serial and RAM's memory view but memory range of ethernet is not accessible for both R/W.
So how can I review this specific memory ? Any ideas ? Or anything that can help me out?

Top replies

Ronan Synnott over 7 years ago +1 verified

Ateeb, could you open the Window -> Show View -> MMU/MPU view to examine the properties of the address of the ethernet controller? This may explain the issue you are seeing. It may also be that this region...

Parents

0 mateeb over 7 years ago in reply to Ronan Synnott

Yes I have examined the Ethernet properties in MMU/MPU > Memory Map and this memory is readable/writeable in EL1. See screen shots below
Stuart Hirons
@Ronan I have also tried DS-5 v5.29.0 and behavior is the same as above.
Cancel
Vote up 0 Vote down

Cancel

Reply

0 mateeb over 7 years ago in reply to Ronan Synnott

Yes I have examined the Ethernet properties in MMU/MPU > Memory Map and this memory is readable/writeable in EL1. See screen shots below
Stuart Hirons
@Ronan I have also tried DS-5 v5.29.0 and behavior is the same as above.
Cancel
Vote up 0 Vote down

Cancel

Children

No data