We are running a survey to help us improve the experience for all of our members. If you see the survey appear, please take the time to tell us about your experience if you can.
Hi Forum.
I'm new to ARM, but have experience with AVR. I'm just trying to make a Hello World with blinky LEDs. I have this board:
https://forum.micropython.org/viewtopic.php?t=3086
So ok, everything seems to be setup right. I can compile and also program the Flash, it verify's with no errors. There are two onboard LEDs connected to A6 and A7 (it says so in the link, but I have also double checked). I can't get them to blink or flash.
This is my code:
#include "stm32f407xx.h" void myDelay(int times){ volatile int i, j; for (i = 0; i < times; ++i) { j++; } } void ini(void){ RCC -> AHB1ENR |= RCC_AHB1ENR_GPIOAEN; //enable GPIO clock for AHB og RCC GPIOA -> MODER |= GPIO_MODER_MODER6_0 |GPIO_MODER_MODER7_0; GPIOA -> OTYPER &= ~(GPIO_OTYPER_OT_7|GPIO_OTYPER_OT_6); GPIOA -> OSPEEDR |= GPIO_OSPEEDER_OSPEEDR7_1 | GPIO_OSPEEDER_OSPEEDR6_1; //High speed 10 GPIOA -> PUPDR &= ~(GPIO_PUPDR_PUPDR7 | GPIO_PUPDR_PUPDR6); } int main(void) { void ini(); while(1) { GPIOA -> BSRRL |= 0x000000C0; //Bit Set 6 & 7 myDelay(200000); GPIOA -> BSRRL |= 0x00C00000; //Bit 6 & 7 reset myDelay(200000); } return 0; }
I hope someone can help me se what I'm doing wrong?
Best Regards
Ole.