Good morning everybody ..
I'm working on a project in which I use STM32F407VG MCU .. it works perfectly on discovey board
now I bought the chip alone and want to design a circuit that I can program with ST-Link programmer which I bought too
can any one help me with the minimum hardware required to interface STM32F407VG chip with the programmer ? sharing your design is so appreciated because I already lost a lot of money trying to program this chip without being on her discovery board
thanks in advance ^^
Hi,
A search turns up this document from ST's website, which seems to give all the details you require to build clock, power, reset and debug circuits for this range of devices.
Hope this helps.
Chris
You can do it in a two layer board with few bypass caps and crystal, pull out swd pins on a connector to program using St link.