• State Accepted Answer
  • Locked Locked
  • Replies 1 reply
  • Subscribers 349 subscribers
  • Views 4072 views
  • Users 0 members are here
Options
Related
How was your experience today?
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

CNTP_CVAL register write from EL1-NS ("Config-RW")

armdev

Hi,

I am trying to setup timer at EL1 level and not able to write to CNTP_CVAL register.

I would like to know what is the meaning of "Config-RW"  ? It means can be configured ? eg. to be accessed from (NS) EL1 mode ?

If so what/how to configure to achieve it ?

Thanks,

Parents
  • 0 Arm Employee Badge

    Hi,

    Config-RW means it's RW based on the configuration(i.e. it can be RW if required

    configuration is enabled, not accessible or trapped otherwise).

    Please read Traps&Enables section under G6.5.8 CNTP_CVAL, Counter-timer Physical

    Timer CompareValue register in ARMv8 ARM ARM or similar section in the document

    you are referring.

    Regards,

    Sudeep

Reply
  • 0 Arm Employee Badge

    Hi,

    Config-RW means it's RW based on the configuration(i.e. it can be RW if required

    configuration is enabled, not accessible or trapped otherwise).

    Please read Traps&Enables section under G6.5.8 CNTP_CVAL, Counter-timer Physical

    Timer CompareValue register in ARMv8 ARM ARM or similar section in the document

    you are referring.

    Regards,

    Sudeep

Children
No data