Hello
I'm quite a beginner with development of drivers for R52.
I just want, for trials purpose, to write a C interrupt handler (EL1) for some peripheral.
I wrote a very simple "hello world" style and managed to trigger it when my peripheral sends an interruptions to the R52 virtual model.
But now, I would like to know how to clear my interrupt from my C handler, because I do not know which registers must be written and in which order. Could
you please tell me what I have to do to clear my SPI interrupt ?
Best Regards
Frederic
I have another question : when the interruption active state has been cleared, what happens to the value of the register ICC_IAR ?
When returning from my C interrupt routine, the assembly code tries to check the INTID in this register to check if there is any other pending interrupt ...
Does this mean that if there is no other interrupts, the SPI wire which has been handled comes back to 0 and then INTID value is becoming 0x3FF (spurious INT) ?
A read of ICC_IAR0/1 returns the HPPI (highest priority pending interrupt) if there is one which is signal-able, or Spurious/1023. Only an interrupt which is in the Pending state can be selected as HPPI (and by "Pending" I mean the state as defined in the GIC's state machine).For scenario, what we have to think of which interrupts are in the "Pending" state at what times.Let's say you have a device generating a level-sensitive interrupt. At some point the wire was asserted, the INTID was set as Pending and the INTID became the HPPI. You took the exception and read IAR. When you read IAR, that INTID became Active (or Active + Pending) meaning the GIC can't send more instances of that interrupt. Later, writing EOIR (or DIR) clears the Active state. So the question becomes: is the device still asserting (or asserting again) the interrupt wire into the GIC? If no, the INTID will not be Pending and therefore can't be the HPPI. If yes, then INTID will be Pending and might be selected as HPPI. I say "might" because there could be other interrupts around as well.
This doc is for A-profile, but the concepts are the same:Learn the architecture: Arm Generic Interrupt Controller v3 and v4 Version 3.2There's a longer description of the above with some diagrams.