Don't know, whether the question is put right, anyway, I'm debugging an assembler program.
The effect is, that as soon as I enable interrupts using the "cpsie i" instruction, an exception (code=5, buserror) occurs.
"cpsie i"
The PC (TOS) has some weird value (00000007). I can only imaging that some timer or some other asynchronous event is causing this.
I also intercepted the sysTick-Handler by a breakpoint but this isn't being hit. (I'm using STM32CubeIDE 1.9.0 to debug the code).
Is it possible to look ahead just in the moment before I'm about to enable interrupts to detect which interrupt source is pending?
Forgot to mention that disabling IWDG Interrupts (suspend watchdog counters during debugging) didn't help.
I've learnt that IRs are enabled from start on. In this case the IR was disabled a few instructions after Reset.
Then some initialization occurs. Also Systicks are enabled. Cannot say where exactly the Busfault occurs. Will have to narrow it down somehow.
Regarding the vector addresses: yes, they all point to Handler+1.
Thanks for the other tips.
BFSR:
x/b 0xe000ed29 0xe000ed29: 0x04 (IMPRECISERR)BFAR:
x 0xe000ed38 0xe000ed38: 0xf8NVIC Registers are all 0