I use a Cortex-A7 board and write start up code.
I try to use Security Extension.
I use `smc` instruction and make cpu mode monitor mode.
In the monitor handler, I tried to changed stack pointer value for calling other functions.
But after execute `ldr sp, =_stack_start`, sp value is 0x0 (Of course, _stack_start is not 0x0 and I check it in the assembler code).
Therefore, after `push` some registers and `pop` those registers, the data abort excetpions occurred!
How can I change the sp value?
It might be possible to "upload" a small program into RAM using MWW commands (better put them in a script; don't type them each time).
... Of course, a perl script on the host could generate an uploading script, so at least basic debugging *would* be possible; however a bit inconvenient.