We are running a survey to help us improve the experience for all of our members. If you see the survey appear, please take the time to tell us about your experience if you can.
Hello all,
I am a electronic developer. Now i have a problem. I am using uvision 5 and ST link for SW development, debugging and programming.
the program can be successfully compiled, and to Flash in target programming. But the program does not run at all, either after programming or power off and on.
But the program can be run in debugging session without any problems, all desired functionalities are realized. I have no idea what the problem is.
Could you please help me?
thank you very much in advance
Ying
One of these likely uses semi hosting and thus will only work with the debugger.