We are running a survey to help us improve the experience for all of our members. If you see the survey appear, please take the time to tell us about your experience if you can.
Hi, I wanted to write a simple program that doesn’t use interrupts or check any of the possible error flags, but that shows a simple UART application for receiving data. This is a part of the code I wrote.
int uart0Getch(void)
{
if (LPC_UART->LSR & LSR_RDR) // check if character is available
{ return LPC_UART->RBR; // return character
}
return -1;
#include "includes.h"
#include "uart.h"
int value;
extern int main( void )
system_init();
screen1[0]='a';
screen1[1]='b';
screen1[2]='c';
while(1)
//KeyScanProc(buf,screen1);
if ((value = uart0Getch()) >= 0)
send_to_uart(screen1,3);
Yes, in fact I just ran the program with the flush function and the output
was something like: "HEL W". Thank you very much for your help!!! It has
been very useful
2015-01-13 15:32 GMT-04:30 jensbauer <community@arm.com>:
<http://community.arm.com/?et=watches.email.thread> Receiving DataUsing the UART CORTEX M0reply from jensbauer<http://community.arm.com/people/jensbauer?et=watches.email.thread> in *ARMProcessors* - View the full discussion<http://community.arm.com/message/24333?et=watches.email.thread#24333>
<http://community.arm.com/?et=watches.email.thread> Receiving Data
Using the UART CORTEX M0
reply from jensbauer
<http://community.arm.com/people/jensbauer?et=watches.email.thread> in *ARM
Processors* - View the full discussion
<http://community.arm.com/message/24333?et=watches.email.thread#24333>